Search

TinyShield Accelerometer

TinyShield Accelerometer

SGD 22.00

ASD2611-R

Availability: This product is no longer in stock

Measure accelerations in three perpendicular axes. (Model ASD2611).

More details

This Tinyshield features the high performance and low power Bosch BMA250 3-axis accelerometer. The BMA250 allows measurement of accelerations in three perpendicular axes and thus senses tilt, motion, shock, and vibration in your projects. There is also an integrated temperature sensor built in.

Even though the BMA250 is designed to run at 1.8V – the Accelerometer TinyShield incorporates level shifters and a local power supply to ensure proper and safe operation over the entire TinyDuino operating voltage range up to 5V.

You can also use this shield without the TinyDuino – there are 0.1″ spaced holes for power, ground, and the two I2C signals along the side of the TinyShield to allow you to connect a different system.


Specifications

    Bosch BMA250 Accelerometer
  • -> 3-axix (X, Y & Z)
  • -> Digital resolution: 10bit
  • -> Resolution: 3.9mg
  • -> Measurement ranges: +-2g, +-4g, +-8g, +-16g
  • -> Sensitivity: 2g: 256LSB/g, 4g: 128LSB/g, 8g: 64LSB/g, 16g: 16LSB/g
  • -> Zero-g offset (over lifetime): +-80mg
  • -> Bandwidths: 1000Hz… 8Hz
  • -> Low Power: 139uA @2kHz data rate
    I2C Mode used
  • -> Arduino pins A4 and A5 are used by this shield

Built in level shifters and linear power supply to allow your TinyDuino to run up to 5.0V operation.


Check this tutorial out on TinyCircuits here.

No customer comments for the moment.

Only registered users can post a new comment.

Cart  

No products

Shipping SGD 0.00
Total SGD 0.00

Cart Check out

PayPal

Search