MiFare Classic (13.56MHz RFID/NFC) Bracelet - 1KB

SGD 6.50

ADA-921

Availability: This product is no longer in stock

This is a blank MiFare Classic silicone bracelet - often used for parties/events or identification but also found in other systems where a small proximity card is desired. The bracelet contains a NXP S50 chip and an antenna, and is passively powered by the reader/writer when placed a couple inches away

These can be read by almost any 13.56MHz RFID/NFC reader but make sure it can handle MiFare cards as there are a few other encoding standards (like FeLica) They are tested and work great with both our PN532 NFC/RFID breakout board and Adafruit NFC/RFID Shield for Arduino!

These chips can be written to & store up to 1 KB of data in writable EEPROM divided into banks, and can handle over 100,000 re-writes. You can use our PN532 NFC/RFID breakout board or Adafruit NFC/RFID Shield for Arduino to read and write data to the EEPROM inside the tag. There is also a permanent 4-byte ID burned into the chip that you can use to identify one tag from another - the ID number cannot be changed.

No customer comments for the moment.

Only registered users can post a new comment.

Cart  

No products

Shipping SGD 0.00
Total SGD 0.00

Cart Check out

PayPal